Carbide lasts longer and requires less maintenance than steel; however, it is more vulnerable to breaking if placed on an uneven surface, so be sure to use the Carbide Bull Set on a sawed or polished block.
Categories
- Cut
- Drill
- Grind & Polish
- Glue, Clean & Seal
- Move, Fix & Handle
- Carve & Create
- SPECIALS!
- Popular Products
- AL-ORR & KE-NE Stonetools
- ABACO Products
- ABRESSA Abrasives
- ARDEX Tile & Stone Fixing
- AKEMI Stonecare
- BOSCH Power Tools
- CNC & Edge Polisher Tooling
- FEIN Power Tools
- FLEX Power Tools
- FLOOREX Floor Grinding
- GHINES Stone Tools
- GIBSON - FAULDS Stoneworking Tools
- ICS Diamond Saws
- LITHOFIN Stone Treatments
- MAKITA Power Tools
- MASTERFINISH Concrete Grinder
- MEGAPOXY Adhesives
- PROCHOICE Safety Gear
- RAIMONDI Tile Saws
- RILEY Stone Chisels
- RUBI Tile Saws
- SAIT Abrasives
- SHINANO Air Tools
- SIGMA Tile Cutters
- STONECLIP Fixing
- TENAX Adhesives & Sealers
- TROW & HOLDEN Stoneworking Tools
Shop: 2/2 Rofe St, Leichhardt, NSW 2040
Stone Carving Tools »
TROW & HOLDEN Hammers »
Carbide Bull Set »
TROW & HOLDEN 10 lb carbide bull set, use with 32" handle
$600.00
($643.86 †)
For roughing out or shaping large blocks of stone. Using the Bull Set is a 2-person operation - one person holds the hammer angled on its edge, set in place along the edge of the area of stone to be removed, angling the blade slightly toward the outside of the stone. The other person then hits it with the striking hammer. With use, the breaking edge of the hammer will wear down; the hammer can then be turned around on it's handle and the other side used. NOTE: This hammer is not meant to be swung.
